Sea Recovery SRC Aqua Matic 1400-2, Руководство пользователя, Страница: 37 / 223

Important: If the RO Membrane Element and Pressure Vessel Assembly are mounted remotely, ensure
that all high-pressure hoses have sufficient slack and are not pulled tightly into a sharp or immediate bend.
1. Using the supplied ¾ in. (19 mm) ID, clear, braided hose, connect the Suction Line components, Low Pressure
line components and Brine Discharge Line components. Secure connections with the supplied hose clamps.
Ensure that all Suction Hose connections use two (2) hose clamps that have been rotated 180°, with the screw
heads facing the same direction. Using fine sandpaper, remove any flash from the hose-barb fittings. If your
System is not supplied with one or more of the optional components mentioned, then skip it and make a
connection to the next supplied component.
2. Using the supplied 50 feet (15 meters) of ½ in. (12.7 mm) ID, clear, braided hose, connect the Product Water
Line components. Secure each connection with the supplied hose clamps, placing one (1) hose clamp onto
each hose-barb fitting.
Component Interconnect Chart
To Component Inlet Component Outlet
Sea Strainer Inlet Connection
Rinse Clean Inlet Valve left or right port Sea Strainer
Rinse/Clean Container Rinse Clean Inlet Valve unused left or right port
Booster Pump Rinse Clean Inlet Valve center port
Pre-filtration Options Booster Pump
LP Manifold Pre-filtration Options
Rinse Clean Discharge Valve Brine Discharge Tee
Cleaning Bucket Rinse Clean Discharge Valve
Brine Discharge Connector Rinse Clean Discharge Valve
Multi Media Filter Discharge Fitting separate Thru-Hull or Tee at Brine
Discharge Connector
Multi Media Filter Waste Line (if used)
Ultra Violet (UV) Sterilizer pH Neutralizing Filter
Potable Water Storage Tank or Cistern Ultra Violet (UV) Sterilizer
Remote Touch Screen
The Remote Touch-Screen Enclosure Assembly is supplied with an 80 ft (24.4 m) long, NMEA-200 cable for
connection to the Main Control Panel. Place and install the Remote Touch-Screen Enclosure in a location that
meets the following criteria:
• Away from water lines and hoses.
• Away from locations that could be sprayed with water.
• In an accessible and viewable location.
• Within 80 ft (24.4 m) of the Main Control Panel.
Water Tank and Optional Components
Note: These optional components are installed inside the Fresh Water Tank. The high- and low-level tank
switches are not mandatory for System operation; however, they do add features when the System is in
Automatic mode. The choice of make, model and style are left up to the Installer and/or Owner. The switches
must meet the electrical requirements and operations described below. The Installer may also connect an
optional, external alarm to the System, which will alert the Operator when the System shuts down.
35
Installation