SciCan STATIM 900J, Руководство оператора, Страница: 27 / 31

STATIM
900J Operator’s Manual
27
Step 2
Selecting the Time and Date
Note
: If the time and date were set according to section 3.7, this does not have
to be performed again.
1. Power up unit while pressing the MULTIFUNCTION button to access the
User Setup menu.
2. Using Solid Instrument or Hollow or Wrapped Instrument Cycle buttons,
scroll to Time / Date Setup and press the Rubber and Plastic Cycle button
to select it.
3. From the Time / Date Setup menu, set the time and date using the Solid
Instrument or Hollow or Wrapped Instrument Cycle buttons to change the
displayed values and the Rubber and Plastic Cycle button to select. Press
the MULTIFUNCTION button when completed to save your selection.
Step 3
Setting Unit ID
1. Power up unit while pressing the MULTIFUNCTION button to access the
User Setup menu.
2. Using the Solid Instrument or Hollow or Wrapped Instrument Cycle buttons,
scroll to the Unit ID Setup and press the Rubber and Plastic Cycle button to
select it.
3. From the Setup Unit ID menu, use the Solid Instrument or Hollow or
Wrapped Instrument Cycle buttons to Change the displayed values and the
Rubber and Plastic Cycle button to select and move to the next digit. Press
the MULTIFUNCTION button when completed to save your selection.
Step 4
Connecting the SciCan Data Logger
1. Ensure that both the Statim unit and the SciCan Data Logger are OFF.
2. Connect the SciCan Data Logger to the Statim unit by using the serial cable.
3. Power up the SciCan Data Logger
4. Power up the Statim unit.
5. The LCD will display the following
sequence of messages:
6. Insert USB Flash Drive or SD memory card
7. After a few seconds the LCD will display the
following sequence of messages:
HH:MM DD/MM/YYYY Time/Date
7. The Communication Port
001 UNIT ID
HH:MM DD/MM/YYYY
"MSD NOT DETECTED"/"INSERT
MSD/FLASH"/"SELECT A CYCLE"
HH:MM DD/MM/YYYY
USB/FLASH DETECTED/SAFELY
REMOVE MSD/SELECT A CYCLE