Schulze PRETREATmaker LINE 11-6, Инструкция по эксплуатации

Страница: 11 / 20

3.4 Changing the precoating liquid during operation
In order to switch from precoating tank 1 to precoating tank 2 move the switch "tank change" from tank 1 to tank 2. Always flush the pump
afterwards for at least 20 seconds with the new precoating in order to properly fill the pump. To do this press the precoating button for at
least 10 times.
3.5 Barcode printing
PRETREATmaker LINE can be equipped with an input interface and a barcode scanner.With this option job parameters can be
transfered directly into the machine without doing any manual parameter adjustments. With the Program „Pre4 barcode v 2” (Foto 1) work
parameters can be set up an printed with a barcode printer (CODE 39). Work parameters can also be generated with another system and
transferred to the machine. Job parameter setup needs to follow these rules: (read from left to right)
The first 2 numbers represent the code version (20)
Next 2 numbers are for binary number (nozzle off or on) (0b000xxxxx)
Next 2 numbers are for spray start (in cm)
Next 2 numbers are for spray stop (in cm)
Next 3 numbers are for carriage speed (050 - 150%)
Next number is for setting um cm or inch (1 = inch / 0 = cm)
Next number is for setting up double spray option(1 = on / 0 = off)
Next number is for table setting (1 = on/ 0 = off)
3.5 Configuration of the barcode scanner
If the scanner does not work properly the codes below should be scanned in order to configurate the scanner. Then switch off the
machine, wait around 10 seconds and switch it on again.
BACK TO THE FACTORY SETTINGS
CONFIGURATION OF THE BARCODE SCANNER
Version 18.04
11/20