Schulze PRETREATmaker LINE 11-6, Инструкция по эксплуатации

Страница: 12 / 20

4. Maintenance
4.1 Daily maintenance
The device should be cleaned with a dry cotton cloth every day (pictures 1 – 2) . Dry the inside walls of the machine. Always remove all
precoating residues. The containers must be controlled many times during operation of the machine. At least once a day the drip trays
have to be controlled end emptied if needed.
(pictures 3-4) . The surface of the base plates and heat plate need to be clean all the time.
The heat plate has to be cleaned with a clean and dry cloth (picture 5) . Do not touch the heat plate – danger of burns. Following the
completion of work the bottom parts of protective covers have to be cleaned (picture 6). Clean the arms of the base plates and the
surface of the drip trays several times a day (pictures 7 – 8). It must be remembered that the guide rails of the cover should always be
greased (picture 9) . Those guides have to be greased with water resistant grease using a brush (picture 10) . It prevents rusting the rails
and protects the rails against precoating liquid.
1. Don’t let the liquid flow over the waste-water container. The container should be emptied if the need arises.
2. The containers with pre-coating liquid should be shaken every day and filter in the container must always be immersed in the liquid.
3. Check the container with distilled water every day.
4. The nozzles must be kept clean. Instructions for cleaning of the nozzles are given in chapter 4.3.
5. Every day after completion of work, press the water button 3 x 1 sec. on the touch screen display. This shall rinse the valves and
nozzles with water.
6. After rinsing, disassemble the nozzles. Instruction - in chapter 4.3.
7. Before starting to work with the machine, install the nozzles.
8. Press the precoating button 3 x 1 sec. Long on the touch screen display until the nozzles start working at a uniform rate.
9. Definitely, after completion of work, dry the interior of the machine. Make sure there are no effluents in the chamber with the
containers.
10. Once a week all the tubes and precoating pumps should be cleaned with water.
Before make sure that the water container is filled with water
Version 18.04
12/20