Description of Functions
EN
· 30.30.01.02851 · 01 · 03/22
47 / 96
In order to signal that the area gripper is working properly, the left-hand decimal point is still displayed when the
display is switched off.
The display is reactivated by pressing any button or by an error message.
If you activate ECO mode using IO-Link, the display will immediately enter energy-saving mode.
7.12
Locking and Unlocking the Menus
The menus can be protected from unwanted access by means of a PIN code [P1n] or in the IO-Link using “Device
Access Locks”. The current settings are still displayed.
The PIN is set to 000 on delivery. The menus are not protected.
A PIN is recommended because carrying out parameterization while the device is in operation can change
the status of signals.
7.12.1
PIN Code [0x004D]
To enable the lock, a valid PIN code between 001 and 999 must be entered in parameter
in the EF menu or via
IO-Link.
If you attempt to alter a parameter while the lock is active,
will flash on the display and or you will be asked to
enter your PIN code.
The PIN code can be enabled and disabled with the parameter
in the EF menu or via IO-Link (value > 000).
Below is a description of how to set a PIN code using the operating and display element.
In the EF menu, select the parameter
.
1.
Press the
button.
The current PIN code will be displayed, and the digit on the right will flash.
2.
Use the
button to select the first digit of the PIN code.
3.
Use the
to confirm and go to entry of the second digit.
4.
Enter the remaining digits in the same way.
5.
Press the
button to save the PIN code.
The menus are now locked.
If write protection is activated, the desired parameters can be changed within one minute after the correct code is
entered. If no changes are made within one minute, write protection is automatically reactivated.
The PIN code “000” must be set for permanent deactivation of the lock.
Full access to the device is still possible via IO-Link even if a PIN is enabled. The current PIN can also be read out and
changed/deleted (PIN = 000) via IO-Link.
7.12.2
Unlocking the Menus
Menus can be protected against unauthorized access by defining a PIN code
in the EF menu. If you attempt to
alter a parameter while the lock is active,
will flash on the display and or you will be asked to enter your PIN
code.
The menus can be unlocked as follows:
