Control of W-ECO MULTI SYSTEM
3
TD831077
III - 11
2. Optional Controller (remote controller)
7
How to install the remote controller
Remote controller wiring can be extended to a maximum
of 1,000 m.
¶
Do not twist the control
wiring with the power
wiring or run it in the same
metal conduit, because
this may cause malfunc-
tion.
¶
Install the remote control-
ler away from sources of
electrical noise.
¶
Install a noise filter or take
other appropriate action if
electrical noise affects the
power supply circuit of the
unit.
The mounting position for the remote controller should
be located in an accessible place for control.
Never cover over the remote controller or recess it into
the wall.
(1)
When you open the decorative cover, you will see
two gaps under the remote controller. Insert a
coin into these gaps and pry off the back case.
7
When using a wall box for flush mounting
¶
If local codes allow, this remote controller can be
mounted using a conventional wall box for flush
mounting.
(2)
Attach the back case with the 2 small screws
provided. Using a screwdriver, push open the cut-
outs on the back case. These holes are for
screws. Use the spacers and take care not to
tighten the screws excessively. If the back case
will not seat well, cut the spacers to a suitable
thickness.
(3)
Connect the remote controller wiring (3 wires)
correctly to the corresponding terminals in the
electrical component of the indoor unit.
When wiring, do not connect
the remote controller wires to
the adjacent terminal block
for the power wiring. Other-
wise, the unit will break
down.
(4)
To finish, fit the back tabs of the case into the
remote controller and mount it.
Do not supply power to the
unit or try to operate it until
the tubing and wiring to the
outdoor unit is completed.
No.
Accompanying parts
Q’ty
Clamper
2
Wire joints
3
No.
Accompanying parts
Q’ty
Remote controller
1
1
Machine screws
2
2
Wood screws
3
2
Spacers
4
2
M4
×
25
653_
8132
(comes with
20 cm wire)
651_
8132
652_
8132
654_
8132
655_
8132
656_
8132
5
6
CAUTION
CAUTION
CAUTION
Control panel
Decorative
cover
Gap
Gap
Coin
057_0059
Switch box for 1 (no cover)
or switch box for 2 (no cover)
Spacer
M4
×
25
Screws (2)
Remote
controller
Decorative
cover
Under case
(Back case)
1779_M_I
84