Sanyo SAP-KCRV243GJ, Техническое и сервисное руководство

Страница: 58 / 78

55
After the cooling or drying operation has stopped, the indoor fan runs for about 30
seconds to dry out the inside of the air conditioner. (The operating lamps remain off.)
The flap closes after the fan has stopped.
If the room temperature rises above the temperature setting during a drying operation,
the unit performs similar operation to cooling, and when the room temperature approaches
the temperature setting, it performs the humidity-priority drying operation.
The drying operation does not serve to raise the room temperature. (When the outside
air temperature is low or when the heat quantity inside the room is low, the room
temperature will not rise.)
A change made to the temperature setting remains stored in the memory even after
operation has stopped.
If the temperature setting is lowered during a drying operation so that the unit has
switched to a cooling operation, the outdoor unit shuts down for 3 minutes. (This happens
only when one indoor unit is used.)
When the unit is running in the drying operation mode while the temperature setting
is higher than the room temperature, the humidity may not be reduced. In a case like
this, select a temperature setting which is lower than the current room temperature,
and perform the drying operation.
To stop the air conditioner, press the ON / OFF operation button again.
NOTE
This appliance has a built-in 3-minute time delay circuit to ensure reliable operation. When
the operation button is pressed, the compressor will start running within three minutes.
In the event of power failure, the unit will stop.
STEP 1 Press the MODE selector button and select the desired mode.
For heating operation
For dehumidifying operation
For cooling operation
Room temperature control works to ensure that the temperature
stabilizes within a range of
*
2
*
of the temperature setting. For
this reason, the value displayed on the remote control unit may differ
from the actual temperature setting. Before the temperature stabilizes,
this difference may exceed the
*
2
*
range.
The operating lamp of the indoor unit lights in one of the colors
shown below.
*
*
*
STEP 2 To start the air conditioner, press the ON/ OFF operation button.
STEP 3 Press the temperature setting buttons to change the temperature
setting to the desired temperature.
Adjustable temperature range:
30
*
max.
16
*
min.
Operating lamp
Heating
Drying
Cooling
Red
Orange
Green
STEP 4 Set the FAN SPEED selector button to the setting you want.
(Refer to "Adjusting the Airflow Direction" on page 23.)
STEP 5 Presss the FLAP button and set the airflow direction as desired.
(Refer to "Adjusting the Airflow Direction" on page 23.)
NOTE