Sanwa Gemini X, Руководство по эксплуатации

Страница: 23 / 56

Page 23
When using the Auxiliary High and Low function, Auxiliary Channel 3 is NOT a proportional channel. The servo will
travel in one direction or the other to the End Points defined as described in the note above.
[[PROgRaMMing MEnU
The Point Auxiliary function allows you to program Auxiliary Channel 3 to move the servo to up to 6 different points along its travel,
then cycle through those Points using either the TRM switch, by pressing the Left and Right MENU keys, or using the Toggle
Switches. For example, if your model requires a separate 3-position or more switch to operate a feature, the Point Auxiliary
function can be customized to control this.
2) Press the +/INC or DEC/- keys until P_AUX is displayed in the Programming Window and
flashing.
3) To select the P_AUX menu, press and HOLD the +/INC and DEC/- keys at the same time.
When selected, P_AUX will stop flashing.
1) Press the Right or Left MENU key to highlight the AUX menu. AUX will be displayed in the
Programming Window.
Prior to programming the Point Auxiliary function, the Auxiliary Switch should be in the OFF position (pulled DOWN).
Once programming is complete move the Auxiliary Switch UP to turn the function ON or down to turn the function OFF.
P_ aUX - POinT aUXiLiaRY
Choosing the Number of Points
1) From within the P_AUX menu, press the Right MENU key. AUX P 6 will be displayed in the
Programming Window.
High and Low servo travel positions are determined by the EPA-AUX H and the EPA-AUX L End Point Adjustments you
program. For more information, see page 18.
Auxiliary Channel 3 ON-OFF, Continued....
2) To control Auxiliary Channel 3, move the Auxiliary Switch UP (HIGH) and DOWN (LOW). When
you move the Auxiliary Switch UP, HIGH will momentarily displayed in the Programming
Window and the Auxiliary Channel 3 servo will travel to its High position. When you move the
Auxiliary Switch DOWN, LOW will momentarily be displayed in the Programming Window and
the Auxiliary Channel 3 servo will travel to its Low position.
Point Auxiliary servo travel is -100 to 100 and overrides End Point Adjustments programmed through the EPA menu.
PROGRAMMING