Fig 4- 49 Re-coding check window
Select "Check" to carry out the repeat address check. Now, "Check" and "Back" buttons are
disabled.
When the check is completed, all repeated addresses in the loop will be displayed. Now it
can check again, or exit the repeat address check by pressing "Back". The time-out error will be
displayed if repeat value and stop command have not been obtained within 120 sec, and the test
shall be carried out again.
Fig 4- 50 Timeout error
4.4.9 Single point test
The single point test can be used to test operating state of detector/module on site and is
generally used for debugging or fault diagnosis. This document does not describe it in detail. Click
on "Single Point Test" —> "Use Mode"/"Debug mode" menu items, the address selection dialog
box will pop up on the screen, as shown below:
