Note:
The users of each level may change passwords of the same and lower levels. For
example, the system administrator may change its password and the passwords of all
watchmen. However, the system administrator is not allowed to change the password of the
system debugger. This is to ensure there is a solution in case of personnel turnover or lost
password.
Caution: The system will identify the current staff-on-duty by the password entered and
record all the operations. The record may be used as the basis of responsibility tracing in
case of accidents. Therefore, users of each level must keep the passwords in confidence
and from leaking.
Prompt:
Initial password for the system administrator is "111111". The 10 groups of initial
passwords for staff on duty are "0000", "1111" b "9999". After system delivery, please change
these passwords into those easy to memorize by yourself and hard to guess by others. The
system administrator is responsible for assigning passwords for the watchmen, which shall
differ from each other, to facilitate the identification.
4.1.5 FIP/Extender setup
The fire indicating panel is the terminal display unit of the fire alarm control system. It is
divided into two types: 485 bus-indicating panel and detector-indicating panel.
485 bus of the system can be used to manage 99 indicating panel equipment at most. The
bus-indicating panel can also be connected on the detector bus; however, it is required to
occupy the bus address.
The 485-bus indicating panel setup panel is as follows; refer to instructions on detector
module setup for indicating panel setup of detector bus:
Fig 4- 11 Fire indicating panel setup window 1
Modifying method: Find the extender address when the corresponding 485 equipment is
extender. And click on "Register" column to show "√". Double click "Type" to make it “Extender”.
When the equipment is extender, the corresponding “zone”, “building” and “floor” are
meaningless which can leave blank and add information in the “position description”.
Find the address of the fire indicating panel to be registered when the corresponding 485
equipment is FIP. Click on "Register" column to show "√". Double click "Type", "Building" and
"Floor" columns and select type, building and floor in the drop-down box. Enter description
information at "position description" column.
Then press OK button to save the setup and exit; press cancel button to retain the original
setup and exit.
