Page 1
3. SYSTEM ADMINISTRATOR PROGRAMMING
3.1
CUSTOMER-LEVEL ACCESS
Before any customer programs can be accessed, you must first open system programming using the
passcode you have been assigned. This must be done using an LCD 24B keyset. Should it become
necessary to change this passcode, see your Service company.
•
While your handset is on-hook, press
TRSF
and then dial
200
.
The display shows [ENABLE CUS. PROG. PASSCODE].
•
Dial the four digit passcode.
The display shows [ENABLE CUS. PROG. - DISABLE].
•
Dial 1 to enable.
The display shows [ENABLE CUS. PROG - ENABLE].
•
Press
TRSF
. The keyset returns to its idle condition.
•
Now
press
TRSF
and the three digit program code you want to access. Follow the
instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you are in programming, any
delay of more than 30 seconds between key strokes will cause the system to
automatically close programming.
3.2
SET DATE AND TIME DISPLAY
Should it ever become necessary to correct the date and time displayed on all of the keysets, do so as
soon as you notice that they are incorrect. Automatic Night Service will not work correctly and SMDR
records will be of no value if the date and time are not correct.
The display format is as follows:
W (Day of the week, 0-6): eg., enter
0
for Sunday and
6
for Saturday.
MM (Month, 01-12): eg., enter
01
for January and
12
for December.
DD (Day of the month): enter a number in the range 01 - 31.
YY (Year): enter the last two digits of the year, eg. 95.
HH (Hours): use the 24-hour clock and enter a number in the range
00 - 24
.
MM (Minutes): enter a number in the range of 00 - 59.
Failure to enter the time using the 24-hour clock will cause the date to change at 12:00 PM Open
customer programming and follow the instructions below.
ACTION
DISPLAY
1 Press
TRSF 505
Display shows
OLD : 6010184 : 0047
NEW : WNNDDYY : HHMM
2. Enter the new time and date using the
above format
OLD : 6010184 : 0047
NEW : 3020994 : 1445
3. Verify the time and date and re-enter
them if necessary
4. Press
TRSF
to store and exit
programming OR press
SPEAKER
to
store and advance to the next program
