SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 28 / 36

27
OwnersManual-TileSaw-CTC705-Rev11-2023
Main Causes of Belt Failures:
Premature Belt failure can be attributed to the following issues: Tension (too much or too little), Pulley
Misalignment, Damaged Pulleys, Improper Handling or Storage, Incorrect Blade Specification for Material
Being Cut, and Cutting Too Deep.
Symptom Possible Cause Corrective Action
Belt Breakage
Too Much Tension Re ‐ tension Belts
Excessive Shock Load Reduce Load/ Check Blade Specification
Pulley Out Of Round Replace Pulley
Burning of Belt
Too Little Belt Tension Increase Belt Tension
Excessive Load
(Cutting Full Depth)
For Best Performance Only Cut only 1 ‐ /2” to 2” Per Pass
Containments On Belts Replace Belts and Find Source of Containments
Incorrect Blade Specification Replace Blade with One Designed For Material Being Cut
Symptom Possible Cause Corrective Action
Belt Tearing/Ripping Pulley Misalignment Align Pulleys
Belt Rolling Off Pulley Pulley Misalignment Align Pulleys
Belt Cracking
Extremely Low Temperature at Startup Warm Machine Before Use
Exposure To Chemicals or Lubricates Locate Source of Containments and Replace Belts.
Brush Replacement
Brushes will wear with usage and is part of the machine’s basic
maintenance.
Replace the brushes when the motor begins to lose
power. Brushes typically need to be replaced During the life of the
saw. Replace the brushes when the motor begins to lose power,
or if the motor has gotten wet, or the motor is slow to get up to
speed, or any strange noises come from the motor, or if the motor
is experiencing internal sparking. Replace the brushes when the
length reaches 6.6mm (1/4”). It is normal for the brushes to wear with usage.
UPC Description NOTES
70184683358 CARBON BRUSHES CTC705 (2) Set of two (2) Brushes
Dimensions :13mm (H) x 6.25mm (T) x 20mm (L)
70184683359 BRUSH CAP (1) 705 Sold as EACH
SAW MAINTENANCE &
TROUBLE SHOOTING