SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 27 / 36

26
OwnersManual-TileSaw-CTC705-Rev11-2023
8. Place the new belt on the pulleys (see #2 in the Figure: Belt Tensioning ) taking care to
ensure that the micro-v of the belt is in the micro-v of both the motor and blade shaft pulleys.
9. Tension the belt by moving the motor away from the blade by turning the Belt Tensioner Screw
Clockwise (see #4 in the Figure: Belt Tensioning )
until 3/8” of deflection is reached in the belt when
pushed down on the middle.
NOTE: If less than 3/8” deflection is in the belt
it the belt has too much tension and the motor
will need to be moved towards the blade shaft
by turning the screw for the Belt Tensioner (see
#4 in the Figure:
Belt Tensioning )
counterclockwise until 3/8” of deflection is
reached.
10. Verify the Pulley Alignment with a straight edge.
a. Line up the straight edge along the outside face
of the motor and blade shaft pulley as shown in
Figure 1.
b. Misalignment will show up as a gap between the pulley face and the straight edge.
c. Make sure that the width of the outside land is equal on the motor and blade shaft
pulleys.
d. If one of the pulleys is not aligned to the other, it is due to:
a). The motor pulley and the blade shaft are not parallel. [See figure 1]
i. Pulley will need to be moved to align.
b). The pulleys are not located properly on the shafts. [See figure 2]
i. Motor is not straight in the Motor Adjustment Slots
11. Tighten the four (4) Motor four (4) motor retaining screws under the cutting head (see #3 in the
Figure: Belt Tensioning ).
12. Reinstall the Belt Guard and tighten all six (6) of the Belt Guard Retaining screws with lock
washers and flat washers (see #1 in the Figure: Belt Tensioning ).
13. Verify that all hardware is properly tightened.
14. Verify that everyone is wearing the proper PPE.
15. Connect the machine to 115v/60Hx/1 Phase power.
16. Turn on the machine.
a. If any strange noises are present turn of the machine and check all work preformed up
to this step.
17. Allow the machine to run for 15 minutes to properly seat the belts.
18. Once a month check the belt tension or check if the blade stalls in the cut or any squealing or
other strange noise are present in the belt guard area..