SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 15 / 36

14
OwnersManual-TileSaw-CTC705-Rev11-2023
CTC705 Wiring Diagram
Circuit Breaker During Start Up or Not Cutting:

Verify that the power supply voltage matches the motor name plate voltage
Failure to run the motor on the proper voltage will damage the motor and is not covered under
warranty. Improperly wired motors are not covered under warranty.

Verify that the circuit breaker is correct for the machine and voltage being used
o
Although the CTC705 can be used on a 15A circuit a 20A is recommend for best
performance.

Verify that the Extension Cord meets the requirements on See : Extension Cords page 18

Have a qualified Electrician verify that the Electrical Connections are correctly made.

If using a generator, verify that it meets the minimum requirements See : Generators on page 18

Remove the extension cord from the machine and connect the machine directly to the power supply, if the
problem disappears the issue is low voltage due to the extension cord being too thin of gauge, too long,
spliced together, or a combination of all.

Change power source if the problem disappears the issue is with the original power source (Low voltage,
low amperage breaker, or damage breaker)
Most motor issues are due to low voltage, under rated circuit breakers, and or extension cord issues.
Circuit Breaker Trips while cutting: - This is an issue with the Blade or Cutting Method being used or too
long/thin extension cord or extremely low voltage at the machine.

Verify that the Blade Being used is correct for the material being cut

Verify that the Blade is properly exposed

Verify that the Blade is installed properly
GENERAL ELECTRICAL
TROUBLE SHOOTING