SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 19 / 36

18
OwnersManual-TileSaw-CTC705-Rev11-2023
Additional Cutting Features
Cutting Table

The Cutting Table features an adjustable ruler guide (1) enable easy aligning and
measuring of cuts. The Ruler Gide can be removed for longer tiles and finetuned to
ensure accurate measurements of any tile (loose the attachment screws and move left
or right to align the center of the blade with the “0” mark in the Ruler guide then tighten
the hardware.

The Cutting Table also features 45° marks in the form of lines for quick angle cuts.

The included Guide-A-Cut (3) provides a surface for cutting multiple tiles at the same
length by simply lining up the material being cut with the appropriate pre-marked lines
(3) on the cutting table. In addition, the wing nut in the Guide-A-Cut can be moved to
the opposite end to allow for 45° cutting. See the section “
Guide-A-Cut ” below for
additional information.

The 15”x18” cutting table provides more support during larger cutting jobs.
Guide-A-Cut
1. Set the Guide-A-Cut (3) by positioning it on the desired dimension and tighten the wing
nut. Make sure that the rip guide is firmly tightened to avoid slippage. The rip guide can
be used for 90º rip cuts and 45º angle cuts from both the left and right side. (Note the
straight and 45º angled slits on the bottom of the rip guide.)
2. After the Guide-A-Cut is positioned for the desired cut, place material flat against the rip
guide and the measurement rail. For 45º rip cuts, place the corner of material in the
open slot of the measurement rail.
3. Simply line up the material being cut with the appropriate pre-marked lines on the
cutting table.
4. Now you are ready to make your cut.
OPERATION