SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 18 / 36

17
OwnersManual-TileSaw-CTC705-Rev11-2023
Operation
The CTC705 tile saw is designed to cut tiles, stones, masonry products, bricks, and pavers up
to 18” x 18” x 1-3/4”. The CTC705 should always be used wet if dry cutting use only blades
designed for dry cutting and follow all OSHA requirements for dry cutting.
1. Read and understand this manual.
2. Follow all includes safety warnings, warnings on the machine.
3. Ensure that all personal around the work area are wearing proper PPE.
4. Place the CTC705 on a flat, clean surface or if using the Optional Folding Stand with
Worktable verify that the area is flat and clear of any obstructions (the CTC705 water
pan will sit into the pocket on top of the Folding Stand).
5. Verify that the Cutting Table moves freely on the Cutting Table Rails.
6. Verify that the correct blade is being used for the material to be cut.
7. Verify that the Blade is installed correctly. See
Blade Installation page 16 for details.
8. Verify that the Blade Guard is secured to the CTC705.
9. Inspect the machine for any damage. If the
machine is damaged or any parts are missing do
not use.
10. Inspect the CTC705 power cord and Water Pump
Cord for damage.
11. Fill the water pan with water and verify that the
water pump intake is submerged.
12. Connect the CTC705 to the power supply
13. Adjust the cut depth to the required depth and fully
tighten the Cutting Head Locking Knob.
14. Place the material on the worktable where the cut
is required.
15. Unlock the Cutting Table so that it can roll freely
16. Turn on the CTC705 Power Switch
17. Let the motor run for a minute or two and check the water flow
18. Hold the tile against the Back Stop on the Cutting Tile while keeping all fingers, hands,
and body parts away from the blade
19. Slowly move the material into the blade by pushing the Cutting Table towards the
blade.
20. Allow the blade to cut into the material and slowly push the material through the blade
with an even smooth force all while watch the cut line, water supply, and ensuring all
body parts are not in the path of the blade
21. When the blade is approximately 3/8” (10mm) from the end of the material slow the
feed speed to reduce chipping.
22. When finished cutting turn off the machine.
Cutting Head Locking Knob
Cutting Head
Locking Knob
OPERATION