SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 31 / 36

30
OwnersManual-TileSaw-CTC705-Rev11-2023
Water Pump Maintenance
When the machine has not been used for a long period of time, hard packed dirt
may begin to build up inside the pump and block the pump wheel. If the machine is
activated with the immersion pump blocked, the electric motor of the pump will be
damaged within a few minutes! Please follow the steps listed below to clean the
pump before and after operating the saw. Keeping the water pump clean will result in a long
water pump life. Damage to water pumps due to not cleaning, or damage from slurry or
debris are not covered under warranty.
1. At the end of each day remove the water pump from the CTC705 water pan.
2. Place the water pump in a container of clean water
3. Unscrew the pump filter.
4. Clean the immersion pump.
5. Loosen the fixing screws of the pump lid.
6. Take the lid off the pump (be careful not to damage the gasket located inside with a
sharp object!)
7. Clean the pump lid.
8. Remove all dirt and incrustations from the pump wheel.
9. Check whether the pump wheel can be easily turned.
10. Then reassemble the immersion pump correctly and check whether it works properly
by placing the water pump in a container of clean water and running the machine until
clean water is moving thru all the water tubes.
11. Turn the machine off and disconnect the power supply.
12. Clean all debris out of the water pan.
13. NEVER place the water pump or leave the water pump in any slurry, mud, a dirty
water pan, or in any debris.
SAW MAINTENANCE &
TROUBLE SHOOTING