SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 21 / 36

20
OwnersManual-TileSaw-CTC705-Rev11-2023
Wet cutting Blades
DO'S
Inspect blades daily for cracks or uneven wear.
Always use appropriate blade for material being cut.
Inspect arbor shaft for uneven wear before mounting blade.
Always use blades with the correct arbor shaft size.
Ensure that blade is mounted in the correct direction.
Secure the blade to the arbor with a wrench.
Use proper safety equipment when operating the saw.
Periodically check the blade for cracks or bond fatigue.
Always have a continuous flow of water on both sides of blade.
DON'TS
Do not operate the saw without safety guards in position.
Do not operate the saw with blades larger than 7”.
Do not cut dry with blades marked "Use Wet".
Do not exceed manufacturer's recommended maximum RPM.
Do not force blade into material let blade cut at its own speed.
Dry cutting Blades
DO'S
In addition to the following, always follow wet recommendations.
Use appropriate blade for material being cut.
Inspect segment blades for segment cracking or loss.
Do not use damaged blades.
Use proper safety equipment when operating the saw.
DON'TS
In addition to the following, always follow wet recommendations.
Do not make long cuts with dry blades--allow them to air cool periodically.
Do not use the edge or side of blade to cut or grind.
Do not attempt to cut a radius or curve.
Do not cut too deep or too fast into the material.
MAINTANCE & TROUBLE
SHOOTING