SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 23 / 36

22
OwnersManual-TileSaw-CTC705-Rev11-2023
Trouble Shooting (continued)
Problem Possible Cause Solution
Poor machine performance little power

Power cord/extension cable too long or
cable still wound up inside cable drum

Power network is insufficient

Drive motor no longer runs at rated
speed RPM

Use a Power cord extension cable of
the rated length, use a cable drum
with cable fully extended.

Observe the electrical ratings of the
machine and connect it only to a
power network which complies with
these ratings

Have the motor checked by a
qualified electrician and have it
replaced if necessary
Saw blade is blunt

Power cord/extension cable too long or
cable still wound up inside cable drum

Power network is insufficient
Drive motor no longer runs at rated speed
RPM

Use a Power cord extension cable of
the rated length, use a cable drum
with cable fully extended.

Observe the electrical ratings of the
machine and connect it only to a
power network which complies with
these ratings

Have the motor checked by a
qualified electrician and have it
replaced if necessary
Appearance of cut is not optimal

Poor tension in the blade material

Too much load placed on the saw blade

Diamond segments are blunt

Return saw blade to manufacturer

Use a suitable saw blade

Sharpen the saw blade
The center hole in the saw blade
has become wider due to wear

The saw blade has slipped on the motor
shaft when running

The arbor of the saw blade must be
fitted w/ appropriated adaptor ring

Check the receiving flange and have
it replaced if necessary
Saw blade shows blooming colors

Saw blade overheating due to a lack of
cooling water

Lateral friction when
cutting

Ensure optimum flow of water

The material feed is too high;
proceed more slowly
Grinding marks on the saw blade

Material is not being fed parallel to blade

Poor tension in the blade material

Too much load on the saw blade

Ensure that the direction of
feed is absolutely parallel to the saw
blade

Adjust roller table

Have the saw blade tensioned

The material feed is too high,
proceed more slowly
SAW MAINTENANCE &
TROUBLE SHOOTING