SAINT-GOBAIN NORTON clipper CTC705, Руководство пользователя

Страница: 16 / 36

15
OwnersManual-TileSaw-CTC705-Rev11-2023

Verify the cutting method. Forcing the Blade into the material is a sign that either the Blade is NOT correct
for the material being cut or an inexperienced operator. Let the Blade and Machine work for you do not
work for the Blade and Machine.

If cutting hard materials do not use General purpose blades. General purpose blades are designed to cut
multiple soft to medium hardness materials and will not preform properly when cutting harder bricks,
pavers, or other building materials. In correct blade usage is the number one root cause for motor issues.
If you need assistance choosing the correct blade for the material being cut, contact customer service at 1-
800-554-8003.

Verify Extension Cord Length and Gauge See : Extension Cords page 18

Verify voltage at the machine must be 115v
Overload Protector (Thermal) Trips – This is a sign of Low Voltage, Incorrect Blade for Material being cut, or
forcing the Blade through the material.

Verify Voltage at the machine!

Verify that the Extension Cord meets the requirements on See : Power Supply page 18

Verify the cutting method. Forcing the Blade into the material is a sign that either the Blade is NOT correct
for the material being cut or an inexperienced operator. Let the Blade and Machine work for you do not
work for the Blade and Machine.

If the Overload Protector trips immediately when the unit is turned on this is a sign of extremely low voltage
or damage Overload Protector.

Clean Motor by blowing out the fan cover with compressed air

Check the Motor for a damaged

To reset the Overload Protector (Thermal) let the motor cool down for 5 to 10 minutes and then press the
Thermal Overload Protector to reset. The Thermal Overload Protector will not reset unit the unit has fully
cooled.
Electrical Trouble Shooting
Verify voltage to the motor 115v/60 Hz/1 Phase
2.
Verify extension cord
See : Extension Cords page 18
3. What is the motor doing when switch is turned on (nothing, humming, tries to turn on but shuts
off, tripping of circuit breaker) It could be a dirty air filter, a faulty start, or a tripped/damage
power supply circuit breaker.
Nothing happens when the power switch is turned on:
a) No power
b) Tripped Power Supply Circuit Breaker
c) Tripped Overload Protector on machine (see:
Overload Protector (Thermal)
Tips page 18.
Humming or strange noises from motor or gear box:
a) Damage motor or gear box. Most damages are from not using air filters, or not
cleaning and replacing dirty air filters
b) Water in the motor
Tries to turn on but shuts off:
a) Power supply Circuit Breaker verify if correct see Power Supply page 18
b) Too long or thin extension cord see Extension Cords page 18
GENERAL ELECTRICAL
TROUBLE SHOOTING