Sailor 100, Руководство по установке

Страница: 97 / 186

Configuration with the web interface
98-136280-B Chapter 6: Configuration 6-25
6666
Co
n
figur
ati
o
n
Static IP or DHCP Client
If you select DHCP client the network IP address and sub-net mask must be provided by
a DHCP server on that network.
If you select Static IP address you must specify a unique IP address and a sub-net
mask.
DHCP Server Settings.
On LAN ports 1,3 and 4 you can choose to run a DHCP server. Select the check box DHCP
Server . The DHCP server settings are only displayed and can be selected when the port
mode is set to Static IP , otherwise the DHCP server settings are not shown.
The DHCP start and end addresses must be on the same network as the port's static IP.
Sections Preferred use
NETWORK
Host name The host name is used for identifying the ACU in local
networks and in e-mail reports. The default host name is acu.
You can change the name. Letters (a-z), digits (0-9) and
hyphen (-) are allowed as legal characters.
Note: The host name must start with a letter.
LAN Port 1
+ 2 LAN port 1 and 2 are switched, i.e. they share the same IP
address and operate on the same network. LAN port 1 is
intended for connecting the SAILOR Transmodulator
(optional).
LAN port 1 can be set to static IP (default), DHCP client or DHCP
server.
LAN Port 3 LAN port 3 is dedicated as the service port. By default this port
has the IP address 192.168.0.1; the current value can be
displayed in the ACU display.
LAN port 3 is by default connected to the front LAN connector
of the ACU.
LAN port 3 can be set to static IP, DHCP client or DHCP server
(default).
LAN Port 4 LAN port 4 can be used for connection to the Control Panel or
LAN of the vessel.
LAN port 4 can be set to static IP, DHCP client (default) or DHCP
server.
Table 6-7: Setup of LAN connectors
SAILOR100IM.book Page 25 Friday, January 18, 2013 10:28 AM