Saeco D.A. COMBISNACK, Использование и обслуживание

Страница: 40 / 68

40
English
Important
In case the sequence includes more soluble products, the
sequence “SOLUBLE - WATER - % SOLUBLE” will appear
again.
If the programming parameter concerning soluble
(“SOLUBLE - WATER - % SOLUBLE”) is such to extend
powder dispensing beyond water dispensing, the vending
machine stops delivering powder and emits a beep
(insufficient mixer rinsing). Re-check the set parameters to
obtain a correct dispensing (powder dispensing must end
a few instants before the end of water dispensing to allow
a good rinsing of the mixer).
- Coffee Water:
It defines the quantity of coffee to dispense.
Example: “38” indicates that 38 water units will be
dispensed. Reference unit is preset by the manufacturer.
The quantity of coffee is adjustable from “0” to “500”
with steps of 2.
- Sugar:
It defines the quantity of sugar to dispense with the
beverage.
The following table shows the different settings.
- Beverage check:
It allows to perform dispensing tests on the beverage
just set.
Pressing
ENTER
, “PRESS KEY” appears, and you can
choose the key to press relative to the type of dispensing
test:
-
A
key Full beverage;
-
B
key Beverage without cup, sugar and stirrer;
-
C
key Only water;
-
D
key Only powder.
Sugar in beverage
without preselection
Without
1
2
3
4
Without
Settings
0
1
2
3
4
NO
Sugar in beverage
with preselection
Quantity preselected
Quantity preselected
Quantity preselected
Quantity preselected
Quantity preselected
Without sugar
BEVERAGE A
H2O COFFEE : 38
BEVERAGE A
SUGAR: 0
BEVERAGE A
BEVERAGE CHECK
BEVERAGE A
H2O SOLUBLE. 3: 022
BEVERAGE A
%SOLUBLE. 3: 90
Soluble
speed
MAX
MIN
10 100 130
% Soluble
Pump speed
MAX
MIN
10 100 130
% Soluble
Fig. 87
- Water soluble:
It defines the quantity of water to mix with soluble in
powder.
Example: “3” indicates that water will be mixed with
soluble product 3. “022” indicates that 22 units of
water will be dispensed into the soluble product. The
reference unit is preset by the manufacturer.
The quantity of water is adjustable from “0” to “500”
with steps of 2.
- % Soluble:
It defines the speed with which the soluble powder
and the water are dispensed (see graph – Fig. 87).
Dispensing speed of soluble powder and hot water is
adjustable from “10” to “130” with steps of 10.
Setting a value of “10”, the pump works at the
maximum delivery, while soluble product is dispensed
at the minimum capacity with impulses.
Setting “100” both the soluble product and water will
be dispensed at the maximum capacity.
Setting “130” the pump works, with impulses, at
minimum capacity, while soluble product is dispensed
at the maximum capacity.