Rutenbeck TC Plus analog, Руководство по эксплуатации

Страница: 74 / 84

74 7 Function of the TC Plus
In case of a power failure of
the 230 V net or in case of an
unplugged plug power supply
the TC Plus does not work.
The settings, except for date
and time, will be saved and are
available after restoration of the
line voltage, and after plugging
in the plug power supply, re-
spectively.
The behavior of the conventio-
nal switching outputs after a
power failure can be set in the
SWITCHING OUTPUTS MENU
selecting the INIT CONDITION
item for each output.
Selecting On, the outputs will
be switched on after restorati-
on of the line voltage, selec-
ting Off, the outputs will be
switched off after restoration of
the line voltage, and selecting
“xxx” the outputs will be set (to
the same state) as before the
power failure.
The state of the outputs A1 to
A6 will not be changed if the
activated current impulse mode
is activated.
The behavior of the EIB outputs
will be set in the ETS and, in
case of bus or power failure, is
the same as described for the
conventional outputs. After res-
toration of the line voltage the
object states are being reques-
ted. If at one EIB input the
switch-on value is exceeded it
will be processed as alarm and
the alarm procedure will be
run. If negative switch-on valu-
es are set for a group address
and no device is connected,
then the TC Plus recognizes a
“0” and reports an alarm be-
cause of exceeding the switch-
on value.
By using an uninterruptible
power supply, the effects of a
power failure can be avoided. If the DIAL TONE RECOGNI-
TION item is activated (On)
the dialing will be cancelled if
no dial tone is recognized.
The TC Plus then advances to
the next dial attempt.
7.8 Behavior in Case of
Power Failure
7 Function of the TC Plus
7.7 Line Control
The TC Plus analog is equip-
ped with a line control. About
40 seconds after an interrupti-
on of the telephone line, re-
spectively, 15 seconds after a
short circuit of the telephone
line, the local alarm output will
be set and "Line fault" will ap-
pear on the display. The local
alarm confirmation push-but-
ton will reset the local alarm
output and at the same time
confirm the local alarm output.
The TC Plus GSM controls the
signal strength once every mi-
nute. If the signal is too weak
or does not exits the message
“No net available” will be sent
and the output ÖA will be
switched.
The TC Plus ISDN ist not
equipped with a line control.
7.6 Dial Tone Recogni-
tion