Rutenbeck TC Plus analog, Руководство по эксплуатации

Страница: 54 / 84

54 6 Configuration
6.3.2 Initial Operation
6.3.1 Assign physical address
It is possible to connect the
TC Plus to an EIB bus line by
a bus coppler.
In order to put the device into
operation, you have to assign
the physical as well as the lo-
gical address (group address).
Moreover, the functioning of
the bus coppler has to be de-
fined by downloading the ap-
plication program. The appli-
cation program is available as
VD2 file and, thus, can also
be used by ETS 2 and ETS 3. • Connect a PC with EIB soft-
ware (ETS) to the EIB bus
line via the EIB-RS-232 in-
terface.
• Press the programming but-
ton (1) at the bus coppler;
the yellow LED is lit (2).
• After having programmed
the physical address, the
yellow LED will be off.
• With a permanent pen mark
the number of the physical
address on the label on the
lower case cover.
2
1
After having switched on the
power supply it takes about 1
min until the TC Plus has read
all EIB device states. Only
after this initialization time the
TC Plus can be used with the
EIB.
6.3 EIB Configuration