ASSIGNING INTERCOM SYSTEMS TO PORTS
OF
THE TRUNKING
MASTER CONTROLLER
1.
From the "Intercoms" menu, select
The port setup screen should appear
(Figure
2-2). For each intercom system that you have
named,
position the cursor in
the "Baud" column, and press the SPACE BAR to set the baud rate. The default
baud rate for
all
intercom systems is
baud.
9600
baud should only be
selected when a port
of
the Trunking Master Controller is linked to a remote
intercom system over a modem.
2.
For each intercom system, position the cursor in the "Port" column,
and
enter the
actual hardware port number that the intercom system is connected to on the
Trunking Master Controller.
Note
will not allow
you to assign the
port number to more than one
intercom system.
To
erase a port assignment
so
that it can be used elsewhere,
position the cursor over the port number and press the SPACE BAR.
In the
example below, the Port
8
assignment was erased from Icm
8
so
that it could be
used for Icm
Help
F i l e
Trunks
Intercoms
S t a t u s S o r t Screen Log Options Master
Intercom Setup Data
Changed
F i l e : On-Line
Mode: On-Line
Figure
Intercom Port Setup
CStrunk
User
Manual
