Rottler SG9A, Руководство по эксплуатации и обслуживанию

Страница: 8 / 55

Introductions / Safety / Installation 2-3 SG9A Manual
www.rottlermfg.com
NEVER OPERATE A MACHINE WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS OR ALCOHOL. Full
mental alertness is required at all times when running a machine.
NEVER ALLOW UNSUPERVISED OR UNTRAINED PERSONNEL TO OPERATE THE MACHINE. Make sure
any instructions you give in regards to machine operation are approved, correct, safe, and clearly understood.
IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES performing the intended operation, stop using the
machine! Then contact our service department or ask a qualified expert how the operation should be performed.
No list of safety guidelines can be complete. Every shop environment is different. Always
consider safety first, as it applies to your individual working conditions. Use this and other machinery with caution
and respect. Failure to follow guidelines could result in serious personal injury, damage to equipment or poor work
results.
Electrical Power:
DANGER
All electrical power should be removed from the machine before opening the rear
electrical enclosure. It is recommended that the machine have a electrical LOCK-OUT device installed.
Make sure all electrical equipment has the proper electrical overload protection.
In the event of an electrical short, grounding reduces the risk of electric shock by providing a path of least
resistance to disperse electric current.
WARNING
Electrocution or a fire can result if the machine is not grounded correctly. Make sure the
ground is connected in accordance with this manual. DO NOT operate the machine if it is not grounded.
No single list of electrical guidelines can be comprehensive for all shop environments.
Operating this machinery may require additional electrical upgrades specific to your shop environment. It is your
responsibility to make sure your electrical system comply with all local codes and ordinances.
When you doing any operation on the cylinder head; the machine is capable of throwing metal
chips. Eye protection must be worn at all times by the operator and all other personnel in the area of the machine.
WARNING
The operator and nearby personnel should be familiar with the location and operation of
the Emergency Stop Button.
Make sure all electrical equipment has the proper overload protection. The SG9A should have a fully isolated
power supply to prevent damage and uncontrolled movement of the machine.
If the SG9A is on the same power lines that are running to other electrical equipment (grinders, welders, and other
AC motors) electrical noise can be induced into the SG9A electrical system.
Electrical noise can cause the controller to see false signals to move. Not supplying a fully isolated supply to the
machine may void factory warranty. Refer to the Power supply section later in this chapter for voltage and
amperage requirements of the SG9A.
Machine Operator:
The operator of the SG9A should be a skilled machinist craftsman who is well versed in the caution, care, and
knowledge required to safely operate metal cutting tools.
If the operator is not a skilled machinist he/she must pay strict attention to the Operating Instructions outlined in this
manual, and get instruction from a qualified machinist in both production and operation of this machine.