Rottler SG9A, Руководство по эксплуатации и обслуживанию

Страница: 12 / 55

Introductions / Safety / Installation 3-7 SG9A Manual
www.rottlermfg.com
Machine Capacity:
Do not attempt to use the machine beyond its stated capacity or operations. This type use will reduce the
productive life of the machine and could cause the breakage of parts, which could result in personal injury.
Avoid Accidental Starting:
Make certain the main switch is in the OFF position before connecting power to the machine.
Careless Acts:
Give the work you are doing your undivided attention. Looking around, carrying on a conversation and horseplay
are careless acts that can result in serious injury.
Job Completion:
If the operation is complete, the machine should be emptied and the work area cleaned.
Replacement Parts:
Use only Rottler replacement parts and accessories; otherwise, warranty will be null and void.
Misuse:
Do not use the machine for other than its intended use. If used for other purposes, Rottler Manufacturing disclaims
any real or implied warranty and holds itself harmless for any injury or loss that may result from such use.
Placement:
Air supply is connected at the right, rear of the machine, at base of upper casting. Connection can either be a quick
disconnect or permanent threaded connection. Be certain to use an adequately sized air line, permitting proper
operation of float. Air pressure should never drop below 90 PSI at any time. Failure to provide adequate air supply
may cause improper floating and clamping.
At this time, some customers will install a T fitting or manifold at the regulator, allowing another air hose to be
connected, providing a connection point for air tools. The auxiliary hose, if fitted, should be of sufficient length to
easily reach the entire front of the machine.
This machine comes pre-wired and ready to be connected to the power source. The power source should meet all
local and national electrical codes. This service should connect to its own circuit breaker or fuse. In most cases the
machine will require 220 VAC, 15 amp, single-phase service but you should verify voltage requirements by
inspecting the electrical tag located on the rear of the machine.