Rottler SG9A, Руководство по эксплуатации и обслуживанию

Страница: 9 / 55

Introductions / Safety / Installation 2-4 SG9A Manual
www.rottlermfg.com
The SG9A machines have the following areas of exposed moving parts that you must train yourself to respect and
stay away from when they are in motion:
WARNING
Cutting Tool Area – Any operation involving hands in the tool holder, such as inspection or alignment of the tool
holder or tools, changing tool holder or insert holders, tool insertion, and removal, tool holder changes, and size
checking etc. requires the machine to be in neutral or on the off position.
Machining – Eye protection must be worn during all operations of the machine. Hands must be kept completely
away from the cutter head.
Work Loading and Unloading – Carefully develop handling methods of loading and unloading work pieces so that
no injury can result if hoist equipment or lift connection should fail. Periodically check lift components for damage
that may cause failure of Cylinder head Handler Assembly.
Machine Maintenance – Any machine adjustment, maintenance or parts replacement absolutely requires a
complete power disconnection from the machine, this is an absolute rule.
Emergency Procedure:
Assuming one of the following has occurred: tool bit set completely off size, work piece or spindle base not
clamped, spindle is not properly centered, and these mistakes will become obvious the minute the cut starts
PRESS THE EMERGENCY STOP BUTTON (on the front control panel) IMMEDIATELY!
Find out what the problem is; return the spindle to its up position without causing more damage. To restart the
machine, turn the Emergency Stop Button CW until the button pops out. Make sure the button has been depress
for at least 1 ½ minutes or the drive will not have time to reset and they will not function.
Be alert to quickly stop the machine in the event of a serious disruption of the boring process either at the top or
bottom of the bores.
“REMEMBER” metal cutting tools have the speed and torque to severely injure any part of the human body
exposed to them.
Air Supply:
It is very important the air source for the SG9A machine be
moisture free. Water and oil in the line will result in early cylinder
and valve failure. The factory recommends installing a water trap
at the machine.
Attach a 100 P.S.I. air source to the appropriate intake in the
small enclosure located on the left rear of the machine near the
bottom.
Bellow you will se the Air regulator panel for the different settings
on the flouting planes on the machine.
And cabinet cooler air regulator.