Rottler SG9A, Руководство по эксплуатации и обслуживанию

Страница: 10 / 55

Introductions / Safety / Installation 2-5 SG9A Manual
www.rottlermfg.com
Air Adjustments:
Float:
The float regulator is located at the rear of the spindle base on the bottom of the interconnect box.
If the machine is not floating properly, it could be from too much or too little air from the regulator. Turn the regulator
all the way off (full counter clockwise).
Start turning the regulator slowly clockwise while continually checking the Work Head for proper floatation. Once
the correct float is established, lock the regulator into place by pushing in on the blue adjusting knob.
:
Use as little air as possible to achieve correct floatation. Using too much air will could cause the
spindle base to move slightly to the right when going into tilt. This will cause a scratch up the side of the cylinder.
Power Supply:
This machine has the following power requirements:
208 to 240 VAC it shut not exceed 240 Volts
Single Phase
50 or 60 Hertz
30 amps
See illustration below for correct connection of “measured” incoming power. connect single phase wiring to the
main rear enclosure, located on the right rear of machine base. The connection point for power is located inside the
enclosure. The connection termination point is located on the left hand side of the electrical panel about half way
up. Connect L1 to the grey terminal block, L2 (neutral) to the blue terminal block. Attach wire from the grounding
rod to the second green and yellow terminal.
Important: Electrically connect in accordance with national and local electrical codes.
Grounding:
This machine must be
connected to a good
earth ground rod. A 6
foot, ½” diameter, 15
OHM, Copper
grounding rod driven
into the earth next to the
machines is preferred.
Not providing a
grounding rod could
void factory warranty.