Rottler SG9A, Руководство по эксплуатации и обслуживанию

Страница: 16 / 55

Sharpener / Vacuum Tester 5-1 SG9A Manual
www.rottlermfg.com
Chapter 5 Mounting Tool Sharpener:
Mount tool sharpener on right hand side of machine using the
cap screw provided with machine.
Rottler Tool Bit Sharpener
When you sharpener the Rottler form Carbide bits, consists in
restoring the tool cutting angle by grinding the face.
To sharp the carbide bit must be fitted on the bit holder also
fitted on the tool holder.
The tool holder will be placed on the adjustable 3/8 fixture of
the tool sharpener.
Slide the tool holder on the fixture, and release the adjusting
knob.
Adjust the fixture to bring the carbide bit flat against the
grinding wheel.
Make sure the carbide tip face is perfectly parallel to the
wheel face by pushing it with the thumb.
Once a good setting is achieved, lock the adjusting knob.
Before to start the grinding motor, move the carbide bit away
from the wheel by rotating the tool holder.
The motor should then be started and the carbide tip face will
just be cleaned.
There is no need to remove a lot of stock from the carbide bit. Sharpening only consists in providing a new cutting
face.
Built In Venturi Vacuum Tester:
Designed to test valve seat and seat surface seal, and particularly to measure the valve seat surface quality after
machining. Including a set of 7 pads and connecting extension to fit must common ports.