Rottler P69AHD, Руководство по эксплуатации и обслуживанию

Страница: 70 / 210

Section 5 Operating Instructions P69AHD Manual
www.rottlermfg.com
5-26
With the probe positioned just above the seat side (in this example) uncheck the closed sections that
we just probed and check the remaining closed section planes along with the seat side plane as shown
below. Notice this time only the seat side planes are showing. The manifold planes have been unchecked
and the seat side planes have been checked. Since we already probed the divided line this will be
unchecked.
However, please note that it is possible to probe the divided line along with the seat side of the port. This
will be done in the case that the probe was not able to probe from the other side due to shanking while
probing. It can vary sometimes depending on where the plane is located in the port and the ease at which
the probe can reach this position.
Click on ‘Probe Checked Planes’ to begin the digitizing process from the seat side. Repeat the same
process used from the manifold side until the probe has completed the probing routines throughout all of
the planes.
After probing all of the planes you should now see that all of your cross sections at each plane level that
have been defined. This time check all of the closed sections including manifold side, divided line, and
seat side. Next click on the Program tab and view all of the digitized cross sections that make up the
entire port