Rottler P69AHD, Руководство по эксплуатации и обслуживанию

Страница: 58 / 210

Section 5 Operating Instructions P69AHD Manual
www.rottlermfg.com
5-14
Right click on “Closed Sections” then click on “Add New Plane for Probing”. A message will come up
verifying that you are using tool #3 as your probing tool. Click ok. An ‘AddPlane Wizard’ will appear. Above
you will see locations for Points 1, 2, and 3. Once the AddPlane Wizard comes up it will automatically turn
the probe on and it should be blinking green. Note that the probe will automatically turn off after 90
seconds if it goes un- activated. It will reset to zero seconds once activated (note: probe becomes
activated when contact is made with the head). Position your probe near where point #1 is from the above
photos by using the hand-wheel. Once the probe is in this approximate position, handwheel shown with
the “Z” axis in the 0.001 increments, with your probe still active, until the probe has touched the metal
surface. Once contact has been made you will see the light of the probe turn red. Hand-wheel the probe
back away from the metal surface until the light turns green again.
With the AddPlane Wizard still open, under point 1 below, click on ‘Set Last Probed’. This will collect the
X,Y, Z point in space at the exact location the probe last made contact with the head. When you are done
collecting points #1, #2, and #3 your AddPlane Wizard will look similar the second figure below where all
the x,y, and z points have been collected. Click OK. You have now defined plane #1.
(Take note that you will be in the ‘SET ZERO’ location under ‘SETUP’. Also note that the
‘ADDPLANEWIZARD’ will appear over the top of your hand-wheel function in which case you will left click
and hold the blue strip on the top part of the wizard to move it to a desired location.)