Rottler P69AHD, Руководство по эксплуатации и обслуживанию

Страница: 68 / 210

Section 5 Operating Instructions P69AHD Manual
www.rottlermfg.com
5-24
Probing Defined Planes
When you begin to digitize you will isolate each half of the port by checking the closed sections you wish
to probe first. For example you can start off by checking the ‘manifold side’ through the ‘divided side’
sections first, as shown below. This will begin the digitizing process starting from the manifold side and
in this case to the ‘divided line’. Once you probe the dividing line it won’t be necessary to probe it again
when you start your probing process from the seat side. (when digitizing make sure to have the prove
above the plane from where it’s going to start)
Notice that the only planes visible on the screen are the “manifold side”, “divided line”, and “closed
section” planes. The planes that represent the other half of the port have been shut off. The planes that
we have defined below are simply a road map for the probe to move to begin its digitizing process. The
probe will find it way to the middle of each plane then at that level will start moving out to find its way to
the edge of the port.