Rottler P69AHD, Руководство по эксплуатации и обслуживанию

Страница: 71 / 210

Section 5 Operating Instructions P69AHD Manual
www.rottlermfg.com
5-27
Cross-Section Manipulation
The little squares that you see on the right side of the screen are all the points the probe has located
when probe made contact with the port. You can use your mouse to move the squares around to obtain
the shape you are wanting at each cross-section level.
To accomplish this simply use your mouse and position pointer over the square you want to move and
hold your left mouse button down and then move the square into desired location. This is particularly
affective if the probe finds its way into a support guide or a bolt hole that has penetrated the port. Look at
the before and after below
To make it easier to manipulate the data points and get a better shape, especially on the turns as shown
in the picture below. You can select a point and press the “control” key on the keyboard while clicking
on the point, then the mouse over the next point and repeat the process, control click. This will highlight
the two separate points to use as a reference. Now right click on one of the highlighted points, a window
will come up and you can select make arc, then easily manipulate all the data points in between the two
highlighted data points.
ORIGINAL PROBED DETAIL
DETAIL AFTER POINTS HAVE BEEN MOVED