AEP-CHS-20191117 44
2.
When changing the material of the printout, if the nozzle temperature set value is
different from the set temperature of the previous material, perform PID tuning again
according to the nozzle set temperature to maintain the surface quality of the printout.
3.
The geometry that can be printed without supporter improves the surface quality of the
printout by setting the fan cooling speed value by 30% more than the previous setting.
(NewCreatorK setting position: advanced setting-> cooling-> adjust the maximum speed
value)
[Warning]
1.
If the nozzle is left at high temperature for more than 10 minutes without the nozzle
loaded, the filament may burn and the nozzle may become clogged.
2.
If grease applied to X, Y, Z shaft and screw disappears, apply heat-resistant Teflon grease.
(Be careful not to contaminate the glass bed with grease.)
3.
When replacing the filament or removing the filament attached to the bed while the
equipment is warmed up, wear the provided gloves to avoid burns.
4.
Be careful of burns as the printer case may be hot while printing.
5.
In order to maintain the durability of the bed, preheat the bed to about 50 ℃ even if there
is no output on high humidity days.
6.
When outputting low-temperature materials (PLA, PC) with the internal temperature set to
0, open the front door so that the chamber temperature is maintained at about 20 ℃ ~
30 ℃. (If you print with the front door closed, the bed temperature may cause the chamber
temperature to rise, resulting in poor output quality.)
7.
Do not connect any other electrical equipment to the power outlet.
8.
Be sure to ventilate during long time printing or after finishing printing.
9.
Remove printouts using the provided scraper to prevent overstress when the bed
temperature drops below 50 ° C.
10.
The printer should be used only by qualified personnel who have completed AEP SERIES
operational training.