AEP-CHS-20191117 29
4. Select a length of 0.1 mm. Insert a piece of print-size paper between the bed and the nozzle,
slide it back and forth, and click the up and down arrow buttons of bed to align the spacing
between the nozzle and bed, as pictured below.
5. Select [OFF] in [Printer View]> [MOTION]> [Motor].
6. Manually place the extruder at each corner of the bed and adjust the gap between the nozzle
and the bed glass by adjusting the nuts under the bed. Repeat at least 2 times in the order of 1,
2, 3, and 4.
7. When the adjustment is complete, remove A4 paper and move the nozzle to the center to
ensure that the nozzle does not scratch the bed glass.
8. After all adjustments, move the LCD screen to the main screen.
10.2 Pre-Autoleveling
This step is done when the Extruder has been replaced or the autoleveling sensor has been re-
mounted.
1.
Close the top lid of the printer.
2.
Run NewCreatorK on PC and connect to the printer via the [CONNECT] screen.
3.
Click the [Measure Probe Z Offset] button at the bottom of the Control window.