AEP-CHS-20191117 37
Print directly from the printer’s internal storage
1.
On the LCD display, click [File Print] > [Print].
2.
Identify files stored in the printer.
3.
Click on a file to print. A window will pop up.
4.
Click [Confirm] to start print.
Notes:
1.
Only .gcode files are viewable on the LCD screen when using the USB hard drive.
2.
For USB hard drives that do not get detected by the printer, you may need to re-format or
switch it to a FAT32 type to use.
3.
Files uploaded via a USB drive get copied and stored in the printer’s local drive as well.
4.
The size limit of each .gcode file is 1.5 gigabytes.
5.
An unstable Wi-Fi connection may cause files to get broken while being transferred over
from the PC to the printer. Ensure the printer is installed in a well-connected area.
FAQ & TROUBLE SHOOTING
[When the filament does not load]
-
Check the LCD display to make sure that the nozzle temperature is set appropriately for
the filament used (ULTEM™: 380 degrees, PEEK: 430 degrees) and that the difference
between the actual temperature and the set temperature is within 10
°
C.
-
If the nozzle temperature is normal, click the “Pause” button and set the nozzle
temperature 20
°C
higher than the currently set temperature, and start loading the
filament at a speed of 1 mm / s.
-
Clean the nozzle using the provided nozzle cleaning tool
-
If the nozzle temperature is not normal or cannot be solved by the above methods,
contact the after-sales service team.
-
Clean the nozzle with a dedicated cleaning tool before and after use.
[When the nozzle and bed distance need to be adjusted during printing]
-
To adjust the distance between the nozzle and the bed horizontal, change the “Thermal