AEP-CHS-20191117 28
-
[Language]: It sets the device language to be Korean or English.
-
[Auto Leveling]: It turns Auto Leveling on or off. Auto Leveling is available to set on NewCreatorK
on the PC as well.
-
[Door Sensor]: It turns the front door detection function on or off.
-
[Filament Warmer]: It turns the filament warmer function on or off.
-
[Filament Sensor]: It turns the filament detection sensor on or off.
-
[Chamber Heater]: It enables or disables the chamber heater. The chamber heater operates
automatically but in case of 'ENABLE', 'ON/OFF' can be set manually.
* Tip: Chamber Heater is only supported on AEP450.
-
[Door Lock]: It turns the door lock on or off. In case of "ENABLE", "ON / OFF" can be set
manually.
* Tip: Door Lock is only supported on AEP450.
10. PRINTING
Printing proceeds in the following order of steps:
1. Power on S/W and pre-heat
2. Bed plate leveling
3. Filament loading
4. Setting of printing parameters
5. Slicing and G-Code generation
6. Printing
10.1 Standard Leveling
-
This section “10.1 Standard Leveling” is an extension of section '7.1 Standard Leveling'.
-
Standard Leveling is used when the initial bed level position has been altered and it is difficult
to apply auto leveling.
* Tip: In general, Standard Leveling is not used (while auto leveling is working properly).
-
Manually adjust the bed plate level.
1. Click on ‘Bed Leveling’ on the main screen of
NewCreatorK.
2. Press the home button to center the nozzle.
3. Select Length 1mm and press the up arrow button to raise the bed closer to the nozzle.