AEP-CHS-20191117 11
"ULTEM™ is a registered trademark of SABIC or its affiliates or subsidiaries." Specifications may be
subject to change for improvement without notice.
2.4 Accessories
The AEP series is provided with the following basic accessories:
USB Cable
Power cable: 220V
Dongle : WiFi connection
USB Memory
3 types of hex wrenches: 1.5mm, 2mm, 2.5mm
Scraper
1.8mm pin
Pinset
Adjustable Wrench:
Brush
Gloves
Low-temperature Extruder
Tool bag
Filaments: ULTEM™9085 1 Roll, PLA 1 Roll
3. GETTING STARTED
Always wear gloves to prevent burns.
Check if the power supply is connected correctly to product specifications.
Check if the AEP SERIES body works normally.
Make sure an original filament is equipped well.
Keep the bed surface clean.
At the start, perform manual bed-leveling.
Check the AEP SERIES is set to the desired setting.
Make sure the AEP SERIES main body has reached the desired setting. It is recommended to
warm up the equipment 30 minutes in advance before printing
To operate printing on a PC, install NewCreatorK on the PC and connect with AEP SERIES. PC
and AEP SERIES can be connected by USB cable or Wi-Fi.
Press the LCD button slowly. If you keep pressing the LCD button repeatedly, it may malfunction.
CAUTION