AEP-CHS-20191117 34
see the filament move, modulate the speed between 2mm/s and 25 mm/s until there is
about 5 cm of the filament remaining at the upper end of the tube. Then, click PAUSE on
the LCD screen.
5.
Cut the end portion of the filament at a 45 degree angle with the provided filament cutting
tool.
6.
Mount the filament with the tube onto the extruder (onto the hole located at the top).
7.
On the LCD Screen, click [Printer View] > [Temperature] > [Extruder1] and set the extruder
temperature according to the recommended specification for each filament:
ULTEM™ 9085: 350 ℃
ULTEM™ 1010: 380 ℃
PEEK: 430 ℃
* Tip: PEEK and ULTEM 9085 can be used interchangeably in one extruder; however, make sure
to pre-heat the extruder to 380 ℃ during filament exchange to avoid nozzle clogging.
* Tip: In general, we highly recommend a practice of using one extruder for one material.
8.
Once the temperature starts rising on [Printer View] screen, start loading the filament at
a [Loading speed] of 2 mm
* Tip : When removing the filament extruded out of the nozzle, please use the tweezers
9.
Once the extruder has been heated to its set temperature, press LOAD at a speed of 2
mm/sec.
*Tip: When removing the filament extruded out of the nozzle, please use the tweezers
10.
Once the filament load is complete, press PAUSE on the LCD screen and set the extruder
temperature back as guided in step 7.
10.5 Filament Removal and Cleaning
1.
Select [Filament] > [EXTRUDER 1] in LCD display.
2.
Preheat the solidified filament by raising the nozzle temperature in [Temperature]
window.
3.
Select [UNLOAD] in order to extract the filament out of the nozzle.
4.
After removing the tube while pressing onto the fitting on the nozzle, cut the tip at 45
degree angle.
5.
Disinfect the metal pin with alcohol, and then insert it into the nozzle to remove the
debris.
*TIP : Preserve the leftover filament bobbin in the closed package
6.
By selecting [Printer View] > [Temperature] > [Extruder] on LCD display, set the
temperature to 0℃
10.6 Creating G-CODE File