Rittal 4051.021, Руководство по эксплуатации

Страница: 19 / 33

7 Cleaning and maintaining the automatic machine
Ritta l crimping machine R8-I We reserve the right to make technical m odifications 19
EN
7.2 Maintaining the automatic machine
To ensure problem-free operation, the described maintenance work (see sec-
tion 7.3 "Maintenance schedule") must be performed at the specified intervals.
Warning!
Risk of fatality due to electric shock!
Uninsulated parts can be touched when working inside the auto-
matic machine.
◼ Switch off the automatic machine.
◼ Remove the compressed air hose first from the compressed air
source and then from the maintenance unit.
◼ Disconnect the mains connector.
◼ Open the front panel and place it down carefully.
Note:
To ensure easy access to all interior areas of the automatic ma-
chine, you should remove the waste container before beginning
maintenance work. Do not forget to replace the waste container
after completing the work.
Note:
Keep the following at hand for maintenance work:
– Allen key set
– Brush and cleaning cloth
– Lubricant
– PTFE oil
– Lubricating grease (suitable for roller bearings)
7.3 Maintenance schedule
Maintenance point Interval / maintenance task See section
Daily
1 Check machine for waste residues
Weekly
2 Clean the conductor holding tongs 7.4
3 Stranded wire fixing unit: Clean the feed-
ing funnel 7.5
4 Perform maintenance on the insulation
stripping unit, check the insulation strip-
ping blades 7.6
6 Cleaning the interior 7.8
Monthly
2 Conductor holding tongs: Oil the pivot
point and the contact surfaces 7.4
3 Stranded wire fixing unit: Oil the pivot
point and the rollers 7.5