5 Configuring the automatic machine
Ritta l crimping machine R8-I
We reserve the right to make technical m odifications
13
EN
Fig. 5:
Transport unit
Legend
1
Transport slider
2
Transport lever pin
3
Release button
4
Sleeve position below the transport lever
◼
Press the release button (fig. 5, item 3) to the right.
◼
Insert the belt until a sleeve is below the transport lever (fig. 5, item 4).
◼
Release the release button.
◼
Press the transport slider (fig. 5, item 1) once, and thus also the transport lever
pin (fig. 5, item 2) down, until two sleeves are located below the transport lever.
◼
Check for correct seating by pulling carefully at the wire end ferrule belt.
◼
Close and latch the front panel.
◼
Roll up the loose wire end ferrule belt.
5.2
Inserting the feeding funnel
The feeding funnel must be changed for the following situations:
–
When a conductor with a different cross-section is to be processed.
Conductor cross-sections are assigned to each letter:
–
A = 0.5
–
0.75 mm²
–
B = 1
–
1.5 mm²
–
C = 2.5 mm²
Retain the feeding funnel at a suitable location near the machine.
◼
Remove the feeding funnel.
◼
Insert the new feeding funnel until a click can be heard.
5.3
Replacing the wire end ferrule reel
◼
Turn the latch on the front panel front so it opens.
◼
Swivel the front panel downwards.
◼
Press the release button to the right.
1
2
3
4
