7 Cleaning and maintaining the automatic machine
Ritta l crimping machine R8-I
We reserve the right to make technical m odifications
23
EN
Additional monthly maintenance:
Fig. 14:
Crimping tool
◼
Check whether the rollers (fig. 14, item 1) on the crimping tool are smooth-run-
ning.
◼
Check whether the rollers (fig. 14, item 2) on the sleeve holding tongs are
smooth-running.
◼
If required, oil both locations.
◼
Oil the guide pin (fig. 14, item 3) of the sleeve holding unit.
◼
Oil the side running surfaces (fig. 14, item 4) of the sleeve holding unit.
◼
Reinsert the stranded wire fixing unit and tighten it.
7.8
Cleaning the interior
◼
Remove the waste container.
◼
Clean the interior of the automatic machine with a brush and, when required,
with a vacuum cleaner.
Note:
◼
Never use compressed air for cleaning the interior, because
small parts (e. g. stripped insulation scrap) may become un-
reachable inside in the automatic machine. Malfunctions and
operational failure can result.
7.9
Maintaining the tool unit
Fig. 15:
Tool slide
1
4
2
3
1
1
