Riello 20161608, Инструкции по установке и техническому обслуживанию

Страница: 31 / 68

31
INStAllAtION
— put the system main switch on "OFF" and the equipment
main switch on "0" (off)
1 Passing electrical connections
1
— punch the connection points of the pre-cut part
— remove the pre-cut part
— remove the sharp edges from the hole
— insert the cable glands supplied
— insert the cable gland supplied (three-phase models)
— insert the cables from the outside guiding them in the di-
rection of the electrical panel
— stop the cables with suitable cable clamps
To access the control panel terminal blocks:
— unscrew the fastening screws
— remove the access panel
— pass the power cable through the cable gland and fix it
— pass the cables for the auxiliary connections through the
cable glands and secure them
— make electrical connections according to the diagrams be-
low
MODEl 005 - 007
L N
10
10
L N
30
40
MODEl 1PH 011 - 015
L
N
MODEl 3PH 011t - 015t
40
10
10
9
For three-phase models it is mandatory to respect the
sequence of phases indicated on the terminal board.
Otherwise the unit may be permanently damaged.
For the sizing of the electrical power cables and safety devices,
use the following table: