Ridder RB50EPLUS, Руководство по эксплуатации продукта

Страница: 6 / 36

3. PRODUCT DETAILS
3.1 Description
The Ridder RB50Eᵖˡᵘˢ tube motor is built-in to a 50 mm aluminium tube (wall thickness 1.5 mm) and
suitable for use with 50 mm winding tubes. Because it is built-in it is possible to wind around the full
width of the tube motor.
The RB50Eᵖˡᵘˢ tube motor is supplied with a 1-phase 2 core asynchronous electric motor for a mains
voltage of 230 V at 50 Hz, an integrated brake and a lubricated gear system. When the tube motor
operates with undervoltage the braking function stays good until a minimum of 190 V. The tube
motor has a thermal protection system. This prevents the burn-out of the drive if the electric motor
becomes too hot.
The RB50Eᵖˡᵘˢ tube motor is almost entirely water resistant. The protection classification of IP55
makes sure that a damp environment has no effect on the tube motor.
The RB50Eᵖˡᵘˢ tube motor has an electronic limit-switch system, with a range of 38 revolutions, that
counts pulses. These counted pulses are used to stop the tube motor at the end positions and in
case of an overload. It is possible to set end positions with an adjusting set. The electronic limit-
switch system also makes parallel connection of tube motors possible.
Together with the Ridder guiding unit and a guiding profile, the tube motor can be installed on the
two sides of a roller screen.
Ridder Drive Systems
T
+31 (0)341 416 854
F
+31 (0)341 416 611
I
www.ridder.com
6