Ridder MotorControl RMC400, Руководство по эксплуатации продукта

Страница: 13 / 36

4.1 Special tools and equipment
No special tools or equipment are necessary to install, to connect or for commissioning.
4.2 Installation
The conditions and starting points that follow are applicable for installation. Make sure that the
working conditions comply with the, local or national, laws and regulations.
• Do not remove the product from the packaging until a short time before the installation.
• Use the correct work equipment and accessories (belts, chains, pallets or such) if it is not
permitted or possible to put the product manually in position.
• The RMC400 is applicable for wall mounting.
• Make sure that you can see the operated system from all control units and control systems. Put
control units and control systems at a height of more than 1.5 m.
• The RMC400 gives information about the system with LEDs on the control board. Thus, easy
access and a satisfactory view is recommended for the location of the RMC400.
Removal cover
• Loosen the cover screws (4x, slot ± 9x2 mm) and the cover temporarily to do all necessary work.
The gasket usually stays in its position.
• Make sure that no damage is caused to the gasket and that it does not become dirty.
• Install the cover again after the work! Refer to the end of chapter 7.
Make sure that the correct equipment and tools are used.
Make sure that easy access to the cover of the RMC400 control-unit
is possible for all work.
(4x)
Slot
± 9x2 mm
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
ridder.com
12
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
ridder.com
13