3.2 Description
The RMC400 is a control unit to control Ridder motor-gearboxes. All
the electrical components of the RMC400 control-unit are built-in to
a plastic housing. Supply is with or without a motor-protection circuit-
breaker (MPCB) and manual control (MC).
The control unit is applicable to:
•
Different supply voltages
•
Different mains frequencies
•
3-phase and 1-phase voltages.
The control unit has a control board with a microprocessor and a
semiconductor relay.
The control board has connections for:
• The supply voltage
•
The power supply for the electric motor (EM)
•
An automatic control signal (24 V AC/DC) from an automatic control-system (ACS)
•
A manual control (MC) (units without a built-in MC)
•
A fault contact (NC) that can be part of an alarm circuit
•
A PTC thermistor in the electric motor (EM) for thermal protection
•
A digital positioning-meter (RPU).
The limit-switch system is also connected to the control board of the control unit.
The RMC400 control-unit transmits control signals from the automatic control-system (ACS) or
manual control (MC) and monitors if these are processed without malfunctions. The control unit has
rotational-field detection and phase detection of the supply voltage.
The 24 V AC/DC control input is protected from:
•
Control in two directions at the same time
•
Sudden changes of direction.
The control unit has status LEDs to show error messages of the system.
The RMC400 control-unit has plug connectors and terminal strips to connect the cables. To pull the
cables through, out of the housing, the control unit also has cable glands. The protection rating of
the RMC400 housing is IP54.
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
8
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
9
Содержание MotorControl RMC400
Страница 36: ......
