21 May, 1999 BIT SWITCHES
4-15
Service
Tables
4.2 BIT SWITCHES
ø
WARNING
Do not adjust bit switches described as "Not used", as this may cause the machine to
malfunction or to operate in a manner that is unacceptable under local regulations. Such
bits are only for use in other areas, such as Japan.
NOTE: 1) This manual does not list default settings for bit switches. Refer to the
System Parameter List.
2) Any changes from the Schmidt1 are shaded.
4.2.1 SYSTEM SWITCHES
System Switch 00
No FUNCTION COMMENTS
0
1
RAM Reset
Bit 1 Bit 0 Reset Level
0 0 No reset
0 1 Reset Level 2
1 0 Reset Level 3
1 1 Not used
Reset Level 3: Erases all image data files
stored in the SAF memory and
communication files (e.g. substitute RX
files). This is the recommended setting
when the SAF requires clearing.
Reset Level 2: This level erases the
following items in addition to those erased
by Reset Level 3: own telephone number,
bit switches (excluding country code),
RTI/TTI/CSI, report data, programmed
telephone numbers (Quick/Speed/Groups,
service station, etc.), NCU parameters, and
personal codes. The NCU country code is
also set to the same as the bit switch
country code (System Bit Switch 0F).
After erasing, the machine automatically
changes these two bits back to 0.
No reset: Normal operation
Cross-reference
RAM Reset Level 1 (Factory reset):
Change the RAM address data from
800005(H) to FF(H), then turn the machine
off and on. In addition to those items erased
by Reset Level 2, the clock, country code
(the default country code is UK), scan
margin settings and print registration
settings are erased.
