Ricoh A230, Руководство по обслуживанию, Страница: 1063 / 1134

Tech Service Bulletin No. A230/A231/A232 – 037 REISSUE
✭
✭ ✭
✭
Page 2 of 4
2. Install the Bushing [B].
3. Remove the Bushing [E] (1 E-ring).
4. Attach the edge of the Grounding Plate [F] (A2844462) to the back of the attachment projection of the
Exit Unit Frame.
5. After removing the Screw [G] which secures the Exit Sensor, attach the Sensor Grounding Plate [H]
(A2844463) to the Exit Sensor and secure it with the Screw [G].
NOTE : Make sure that area [I] of the Anti-Static Brush Assembly is facing inward of area [J] of the
Sensor Grounding Plate at the time of attachment.
Installation Procedure for Bridge Unit
NOTE:
The following action should be taken when a paper jam occurs at the Bridge Unit.
1. Remove the Bridge Unit. Remove the small cover of the drive section [A] (1 Screw).
2. Remove the two Gears [B] and Screw [C].
3. Secure the new Harness [D] (A2845510) with the Screw [C].
NOTE : Make sure that the Harness does not touch the Gear.
4. Attach the two Gears and the small cover. Route the Harness, taking up any slack.
Continued…
[I]
[G]
[H]
[A]
[D]
[B]
[C]
[J]