Rheavendors Group barista XX, Руководство по установке и обслуживанию

Страница: 41 / 49

see 09.01.a.
see 09.01.a.
see 09.01.f.
see 09.01.a.
see 10.
come fare a
by
B
B
A
A
C
C
MAN1920124 rel. 01 dated 23.09.2011 page no. 41 of 48 pages
dispensing starts as soon as the user presses a selection key; the
order in which instant products are poured into the cup depends
upon the values of delays (e.g. the one, the delay value of which is
zero, will be dispensed before the one, the value of which is 40,
dispensed four seconds after the user has pressed the selection
key); pay special attention when programming the delays in
dispensing a product and the water diluting it in the mixing bowl;
except for the instant coffee product, for which just the opposite is
applicable, it is recommended to dispense water before the product
to enable the latter to drop on the water film already present in the
mixing bowl for a better mix; espresso is dispensed before and
after any instant product by programming the variable “coffee
sequence”;
regulation is admitted for boiler pumps (see 05.36. and 05.37.)
within the +/-30% maximum limits only when the programmed
water flow is “average”; when it is “low”, it can be only increased
(max. by 30%) whereas – when it is “high” - the flow can be only
reduced (max. 30%);
the rotation speed of the motors of product mixers (see 05.27.)
can be adjusted between 15,000 r.p.m. and 5,000 r.p.m.; the drink
quality of instant products depends a lot upon the action of the
fans of mixers: instant chocolate generally requires a long mixing
time at the maximum speed for dissolution in water whereas
instant tea shall not be mixed to get a drink quality without any
bubble on the surface;
to extract the residual powder of instant products from inside the
machine (see 05.30.), it is recommended to use the value in
minutes you have already programmed (three); if you should use
particularly volatile products, increase the time to five (and more)
minutes; after having opened the rear panel of the machine, never
forget to connect the knurled suction tube with the rear bush of the
fan;
to check the rotation time of a product motor and a mixer fan or
the activation time of a solenoid valve during the programming
phase, when the display shows “PRODUCT N” or “WATER N time”
or “MIXER N”, press the “PROG” key: the device will be activated
for the programmed time;
to access the neon tube, open the door; use a flat-blade
screwdriver to release the two A “teeth” and rotate the lower part
of the door panel to the outside; unscrew the two B screws, release
the two C “teeth”, rotate the upper part of the door panel to the
outside to access the neon tube;
use neutral detergent products only;
attention
never use abrasive cloths, steel sponges, aggressive or foamy
detergents and other solvents, hot water and acids;
if you should return any material under guarantee that is either
defective or not in compliance with your requirements, fill in the
form “MOD. PO 19.01/2B Materials under guarantee –
Authorisation to return” and send it to the fax number above to
apply for authorisation; only after having received the authorisation
form signed and numbered, you are permitted to send the goods at
your expenses to the address specified by the form;
13.15. programme
delays
13.16. tune the water
flow for instant products
13.17. regulate the
speed of mixers
13.18. powder aspirator
13.19. time tests
13.20. replace the door
neon
13.21. external cleaning
of the machine
13.22. return some
material under
guarantee